DIN5466-2英文版完整版.doc

224444557182222242424 2 2 4 4 4 4 5 5 7 18 22 22 24 24 24 Meeting 13 December 2000 E DIN 5466-2 (11- 1998): Splined joinus: culculation of load capacily 1 Draft standard E DIN 5466-2:1998-11 Sp lined joints: Calculation of load capacit y Part 2: Inrolute splines to DIN 5480 Draft translation by J.A.Pennell, Universiry of Newcastle upon Tyne . NOTE: This Part 2 of the standard has nor yet been published and is thur not authoritative. The document translated is the latesi draft intended only for discussion by the DIN. comminee. Some later additions a nd modifications propased during recent comminee disaussions have also been incorporated into the tex. Warning This draft standard is issued to the public only for checking and comment. Since editing may cause the final text of the standard to differ from this draft, its actual use requires specific agreement of the parties concerned. Comments should be sent to Normenausschluss Antriebstechnik (NAN) at DIN (Deutsches Institut fur Normung e. V.), Pastfach 710864,D-60498 Frankfurt (Germany). Contents 22 2 2 1 Scope, field of application 2 Related standards 3 Symbols, definitions and units 4 Behaviour of joints in service 5 Analysis of joint loading 5.1 Limiting equivalent load radius and load regime 5.2 Maximum normal flank load 6 Geometry-dependent factors for stres analysis 6.1 Longitudinal load distribution factork 6.2 Factors for calculcating shaft stresses 6.3 Factors for calculating hub stresses 7 Estimation of fatigue strength 7.1 Method A (basad on syathetic S-N curves) 7.2 Method B (based on standard fatigue test data) 7.3 Method C(based on fatigue tests on similar splines) 8 Designing to a wear criterion 25Appendix A(for information) 25 References 26Appendix B(for information) 26 Example: Strength calculations for a splined shaft Drqft translation: J.A.Pennell E DIN 5466-2 (11