ABB Connector replacement guide, fan kit cable for ACS880-104 R8i with +C183 and without +C188, or ACS880-304 D8T with +C183 and without +C188 说明(英语)用户手册.pdf

Connector replacement guide Fan kit cable for ACS880-104 R8i with +C183 and without +C188, or ACS880-304 D8T with+C183 and without +C188 The document is applicable to the fan kits of these converter modules: – ACS880-104 frame size R8i with heater +C183 and without DOL fan +C188 – ACS880-304 +A018 frame size D8T with heater +C183 and without DOL fan +C188. Option +V112 indicates that the converter module is equipped with black auxiliary power supply con- nector and fan kit cable connector (= new connector design). Before you start replacing the fan kit of the converter module, make sure that the connector at the end of the fan kit cable is compatible with the counterpart in the module (X55). Black connector is compatible only with the black counterpart, and gray connector only with the gray counterpart. If the connectors are not compatible, replace the connector at the end of the fan kit cable. Use the connector from the old fan kit, or order suitable connector from ABB. Make sure that the wire connections to the connector remain unchanged. Do not mix the order. Ter- minal numbers are also marked in the wires. Wire colors are matched for male-female connector pairs. For all connectors, use a 0.6 × 3.5 mm slot-head screwdriver, and max. 0.6 N·m tightening torque. New connectors can be ordered from ABB Service with these order codes. ABB order code ABB order code Connector type Description (New type) (Old type) 9-pin female Module side 3AXD50000960248 3AUA0000059813 9-pin male Fan kit side 3AXD50000960309 3AUA0000059812 3AXD50001059194 Rev A 2023-05-10 © Copyright 2023 ABB. All rights reserved. Page 1 of 2. The connector is located behind the steel plate at the front of the fan kit.