拆卸机器切割部分的步骤外文文献翻译、中英文翻译.doc

拆卸机器切割部分的步骤外文文献翻译、中英文翻译.doc

  1. 1、本文档共31页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
The following is a procedure for disassembling the entire cutting unit(Figure27).Note that individual spindles and related parts can be removed without disassembling the entire cutting unit(for example,the circular knife spindle and stripper plate can be removed without disassembling any other part of the cutting unit). Figure 27Cutting unit. (1)circular support assembly, (2)impeller (3)crosscut knife spindle, (4)slice gate , (5)stripper plate, (6)slicing knife (7)slice adjustment knob, (8)adjustment nut 1.Ower source must connected to machine and turned on.Turn the power disconnect/lockout switch to the “O”(OFF)position and lock out.Allow machine to come to a complete stop,then press the “I”(start)button and hold for two seconds to verify that the machine will not start.After the green guard locking switch status lights illuminate(when all rotating machine parts are idle)unfasten the draw latch connecting the feed cover door and support housing.Open the feed cover door. 2 .Slide protective sleeve provided with the machine over the crosscut spindle(see “Crosscut Knife Spindle Assembly”,page 80). CAUTION:The following step in this maintenance procedure repuires that the cutting parts be rotated.Use the impeller to rotate the parts.The impeller should only be grasped near the bottom to avoid contact with slicing knife! 3 .Remove the circular support assembly which contains the circular spindle assembly .Rotate the impeller by hand (grasp near the bottom) until the line etched on the circular support assembly aligns with the line on the end of the circular spindle(Figure 28).The open side of the drive coupler must face out(Figure 39,page 45).This can be viewed by looking in the space between the circular support and the support housing.Remove the two locking nuts and pull the circualar support assembly straight out and off of the machine (Figure 29).Place the support assembly on a work surface in a safe palce. Figuar 28Aligning circular knife spindle. (1)Circular

文档评论(0)

***** + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档