catia人体模型培训.pptVIP

* * * * * * * * * * * * * Copyright DASSAULT SYSTEMES 2002 * Do It Yourself (2/12) with Human Measurement Editor Switch the gender Change the proprieties of the rear passenger to (referential H-point) Open human measurement editor workbench and select the manikin Select the female gender and update the manikin Check the impact on the reach and the vision. If you have constraints on hand and foot, just click on update and the posture will be readjusted Explore the workbench to modify the dimension of the manikin Select the manikin you want to change and select human measurement editor workbench. Input the limit to 90% of the population Select the sitting posture from the workbench Double click on the sitting height and put the management on manual Enter 95 percentile Select the reach posture from the workbench and change your point of view from the left side Enter 600 mm, SAFEWORK will tell you that the minimum value is 617.365mm. Therefore enter 620mm and exit the workbench. Once you are exited of the workbench, you can perform again some reach and vision analysis Explore by entering your own dimensions Enter you Weight and your stature Explore what is the most probable values for the other dimensions and and compare with your real dimensions Copyright DASSAULT SYSTEMES 2002 * Do It Yourself (3/12) with Human Measurement Editor Generation of boundary manikin (Ergonomics knowledge recommended) Identify critical variables In order to define the boundary manikins, you first have to determine which anthropometrics variables are going to be used, theses variables are known as critical variables. Each workstation type has its own critical variables that must be selected before defining the boundary manikins. Those critical variables are based on the task that an operator needs to perform in a workstation or while interacting with a product. For example, when assessing a workstation where operator sits, the critical variable could be : Buttock-knee length: for verti