HDPE硅芯管工厂检验报告(中英文).doc

HDPE硅芯管工厂验收报告 HDPE silicore duct Factory Inspection Report 测试目的 Test Purpose 确保出厂产品质量指标符合技术标准要求 测试依据 Test Standard 产品名称 Product Name 规格型号 Product Model Φ/33mm 买方 Buyer 卖方 Seller 测试人员 Tester 工厂结论Inspection Results： 该批经现场随机抽样检测，各项技术指标均符合。 买方：卖方：代表签字： 代表签字： 日 期： 日 期： 验收人员名单 Factory Tester List 姓 名单 位职 务签 字Signature 高级经理 副经理 经理 Φ40/33mmHDPE硅芯管—工厂测试记录Φ40/33mm HDPE silicore duct Factory Inspection repor 项目 Items 检验标准及方法 Test standard and method 要求 Requirement 实测值 Test value 说明 Remark 外观 Appearance 在自然光线下目测。 Checked by eyes under natural light 颜色均匀一致、内外壁平整、光滑，无明显杂质、气泡，产品上标识完整、清晰。 Uniform color, inside and outside walls are smooth, no impurities, bubbles, product identification is complete and clear. 尺寸 Dimension 用分度值0.02mm π尺测量。 Measured by π ruler with division value 0.02mm. 平均外径Φ40+0.3mm Average OD Φ40+0.3mm 用分度值0.02mm卡尺测量。 Measured by caliper with division value 0.02mm. 壁厚3.6±0.2mm Wall thickness 3.6±0.2mm 用分度值1mm的卷尺 测量。 Measured by tape measure with division value 1mm. 长度+0.3%-0m Length 1500+0.3%-0m 测量米标长度，用读数值乘记码数 Measuring meter length, reading records multiplying code No. 包装 Package 按用户确认的包装要求检验 Checking as per customers’ package requirement 标记 Marking 目测标记清晰度；Visual checking marking definition. 米标误差±0.5%。Meter mark tolerance ±0.5%. 按用户确认的要求印字内容检查 Checking as per customers’ marking requirement Verification of the ratio of the pipe diameter to wall thickness (SDR) 检查硅芯管直径和壁厚的比值 SDR11 环刚度 Ring stiffness 按照GB/T24456-2009检测。 Tested according to GB/T24456-2009. ≧50KN/m2 外壁硬度 Hardness of external wall 按照GB/T24456-2009检测。 Tested according to GB/T24456-2009. ≧59HD Air pressure test (leaks) 空气压力测试 用不透气的堵头封闭硅芯管2端，加压至0.2 MPa，保持此压力24小时，看压力值（不变）The whole cylinder of the duct is taken and sealed at both ends with air-tight plugs and the system is then inflated up to a pressure of 0.2 MPa. After keep