Momentum_Power-Up and Shut-Down.pdf

2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power-Up/Shutdown Introduction This document describes how to power-up, initialize, and shut down the Momentum printer. In this Document Refer to the following: Topic See Page Emergency Stop and Main Disconnect Locations 2 Power Up and Initialization 3 Shutdown 6MPM 125, Momentum, Momentum Plus, Momentum HiE, Momentum Elite, Momentum Dual Lane 1 P O W E R- U P / S H U T D O W N Emergency Stop and Main Disconnect Locations Emergency Stop and Main Disconnect Locations Introduction The following shows the locations of the Momentum Elite Main Disconnect and Emergency Stop switches. Refer to the Safety document for descriptions of these switches. Machine Front There are two emergency stop switches located at the front of the machine; one on the left side bezel and one on the right side bezel: Machine Rear The Main Disconnect switch is located at the rear of the machine: E-Stop E-Stop Main Disconnect2 MPM 125, Momentum, Momentum Plus, Momentum HiE, Momentum Elite, Momentum Dual Lane .. .. . P O W E R- U P / S H U T D O W N Power Up and Initialization Power Up and Initialization Description The following describes how to power up and initialize the Momentum Elite printer. ATTENTION Before powering up and initializing the printer, you must verify the position and/ or status of all switches, indicators, doors, hoods, covers, and EMERGENCY STOP buttons. 24 V ON Button Procedure To power up and initialize the printer: 24 V ON Step Action 1 Set the MAIN DISCONNECT switch (at the rear of the machine) to ON. The software automatically starts and the Log On to Windows dialog displays. If the computer does not come on, press the power button on the front of the computer. ATTENTION The Windows XP Administrator password was set to MerlinAdmin by Speedline, but this may have been changed by your internal IT department. Also note that passwords are case-se