点到多点帧中继的配置.docVIP

点到多点帧中继的配置： R1的配置： Router en Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router config #int f0/0 Router config-if #ip add 192.168.1.1 255.255.255.0 Router config-if #no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router config-if #int s0/0/0 Router config-if #no ip add Router config-if #encap frame Router config-if #no shut %LINK-5-CHANGED: Interface Serial0/0/0, changed state to up Router config-if # %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up Router config-if #int s0/0/0.1 %Cannot create sub-interface Router config #int s0/0/0.1 multi %LINK-5-CHANGED: Interface Serial0/0/0.1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0.1, changed state to upRouter config-subif #ip add 1.1.1.1 255.255.255.0 Router config-subif #frame interface-dlci 20 Router config-subif #frame interface-dlci 30 Router config-subif #frame map ip 1.1.1.2 20 broad Router config-subif #frame map ip 1.1.1.3 30 broad Router config-subif #exit Router config #router rip Router config-router #version 2 Router config-router #netw 192.168.1.0 Router config-router #netw 1.1.1.0 Router config-router #end %SYS-5-CONFIG_I: Configured from console by console Router#sh ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set 1.0.0.0/24 is subnetted, 1 subnets C 1.1.1.0 is directly connected, Serial0/0/0.1 C 192.168.1.0/24 is directly connected, FastEthernet0/0 R 192.168.3.0/24 [120/1] via 1